AF1600A - Experimento

Cylinder Model with Pressure Tapping

PDF datasheet

A cylinder model that spans the full width of the working section of the AF1600S Subsonic Wind Tunnel. A holder (included with the wind tunnel) supports the model in the tunnel.

OR CALL US TO DISCUSS+44 1159 722 611

Cylinder Model with Pressure Tapping

The model includes a single pressure tapping so, by rotating the model, students can find the pressure distribution around the cylinder. TecQuipment offers several suitable pressure-measuring instruments (available separately).

Using a Pitot tube, students can traverse the model wake to find the downstream pressure distribution and find the drag on the model. They can compare this to direct measurements, obtained using a balance.

TecQuipment’s Smoke Generator (AFA11, not included) increases the educational value of the experiments by showing the flow of air around the model.

Cylinder Model with Pressure Tapping
SUPPORTING PRODUCTS

There are 1 essential base units for the Cylinder Model with Pressure Tapping

VDAS AF1600S - Package
SUBSONIC WIND TUNNEL 600mm

An open circuit suction subsonic wind tunnel with a working section of 450 mm by 450 mm and 1000 mm long. Package includes the Aerofoil with Tappings, a Three-Component Balance, two Differential Pressure Transducers, a 32-Way Pressure Display Unit and data acquisition (VDAS-F).
AF1600H - Experiment
Aircraft Model - High Wing

The high wing model aircraft with NACA profile wings for use with the Large Subsonic Wind Tunnel (AF1600) is good for experiments with lift, drag and pitching moment of fixed wing aircraft.

AF1600G - Experiment
Aircraft Model - Low Wing

A low wing model aircraft with NACA2415 profile wings for use with TecQuipment's Large Subsonic Wind Tunnel (AF1600S)

AF1600J - Experiment
Three-Dimensional Drag Models

A set of different shape models for use with the Large Subsonic Wind Tunnel (AF1600S) each with identical frontal area to allow students to compare the different coefficient of drag for each shape. Includes a dummy stem for tests to cancel out the drag due to each model’s support arm.

AF1600D - Experiment
A Set of Two NACA0012 Aerofoil with Tappings

This set of two NACA0012 aerofoils allows students to compare the results from a full-width aerofoil with a half width aerofoil.

AF1600C - Experiment
NACA2412 Aerofoil with Variable Flap

A 150mm chord NACA2412 aerofoil with 590 span featuring a variable flap that adjusts +/- 90 degrees for use with the AF1600 Subsonic Wind Tunnel.

AF1600B - Experiment
NACA0012 Aerofoil with Tappings

A 150 mm chord NACA0012 aerofoil with 595 mm span and 20 static pressure tappings.

AF1600F - Experiment
Flat Plate Bundary Layer Model Roughened and Smooth

A pair of boundary layer models with a mounting plate, also a pitot and a static probe for investigating boundary layer. One plate is roughened, the other smooth to allow comparisons on boundary layer growth.

There are 1 recommended ancillaries for the Cylinder Model with Pressure Tapping

AFA11 - Ancillary
GENERADOR DE HUMO

This smoke generator and probe are an optional ancillary to TecQuipment's AF1125, AF1450 and AF1600. It allows the observation of airflow in subsonic wind tunnels and other airflow situations.

NEED MORE INFORMATION?

We're here to answer your questions

Subscribe